Dentemp Recapit No Mix Cement 1g

• Wash hands.
• Prepare crown by carefully removing as much old cement as possible from inside the crown.
• Rinse well.
• Clean and rinse tooth area with water and leave moist.
• Fit the crown back on the tooth before applying new material.
• Make sure it fits properly.
• If you cannot do this, DO NOT PROCEED. See your dentist.
• Make sure inside of crown is dry.
• Open tube by reversing the cap and punching a hole in the tip of the tube.
• Apply a small amount of material onto the upper inside edge of the crown.
• Remoisten tooth area, place crown on wet tooth and press firmly. Bite down several times to ensure a proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal.
• WAIT 5 MINUTES AND THEN GENTLY REMOVE ANY EXCESS MATERIAL.
• RINSE OUT MOUTH WELL WITH WATER.
• Allow at least 1 hour to set before eating.
• Cement will fully set in 1 to 3 hours.

NOTE: When replacing a bridge, apply material sparingly to only 1 hollow tooth at each end of the bridge.

Dentemp Recap-it Cap and Crown Repair should not be used on implants or posts without dentist’s advice.